L60T-T 60 mm Cage Right-Angle Adjustment Mounts

L60T right-angle mounts are shown for approximately 2-inch (50.8 mm) elliptical mirrors. A retaining arm and soft-tip screw locate the optic; three hand knobs adjust the mirror plate in tilt. Five variants differ in metric and imperial post-mounting interfaces, so choose from the dedicated model diagrams rather than the shared photograph. A mirror appears in one installation illustration only and is not confirmed as supplied. The English artwork shows the mount family without an optic.

Optic retention

The supplier describes a 2-inch (50.8 mm) elliptical optic. The front opening and retaining arm are visible. Accepted thickness, contact force and proof of the soft-tip material are not supplied.

Three-knob adjustment

Three hand knobs act on the moving plate to adjust pitch and yaw according to the source description. Angular travel, motion per turn, backlash, drift and load are not specified.

Mounting-hole options

The dedicated images label Z6M-T as M6/M4/6 mm; Z6-T as 8-32/1/4-20/6 mm; ZM-TA as M6/M4/M3; ZM-T as M6/M4/4-40; and Z-T as 8-32/1/4-20/4-40. These refer to different holes identified in each model image, not interchangeable thread sizes for one hole.

Before ordering

Check post system, installation direction and optic size. Confirm whether posts, mirror and mounting screws are included and obtain adjustment data for critical alignment.

Selection checklist

Check elliptical mirror thickness and clearance

Match metric or imperial post holes

Check retaining-arm contact with optic coating

Request travel, stability data and packing list

To be confirmed

Accepted optic thickness, holding force and material

Angular travel, resolution, backlash and stability

Inclusion of mirror, post and fasteners

Exact pack quantity by variant